Trouble Diagnosis Symptom Chart

Make sure other systems using the signal of the following systems operate normally.

SYMPTOM REFERENCE CHART

Symptom	Repair order
None of the power windows can be operated using any switch.	1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
2. Check power window main switch power supply and ground circuit
3. CHECK POWER WINDOW SERIAL LINK
Driver side power window alone does not operated.	1. CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) CIRCUIT
Driver side power window alone does not operated.	2. Replace power window main switch
Front passenger side power window alone does not operated.	1. CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) POWER AND GROUND CIRCUIT
	2. CHECK POWER WINDOW SERIAL LINK
	3. CHECK FRONT POWER WINDOW MOTOR (PASSENGER SIDE) CIRCUIT
	4. Replace BCM
Rear LH side power window alone does not operated	CHECK REAR POWER WINDOW MOTOR (LH) CIRCUIT
Rear RH side power window alone does not operated	CHECK REAR POWER WINDOW MOTOR (RH) CIRCUIT
Anti-pinch system does not operate normally (driver side)	1. Door window sliding part malfunction A foreign material adheres to window glass or glass run rubber. Glass run rubber wear or deformation. Sash is tilted too much, or no enough.
	2. Limit switch adjusting
	3. CHECK LIMIT SWITCH CIRCUIT (DRIVER SIDE)
	4. CHECK ENCODER CIRCUIT (DRIVER SIDE)
Anti-pinch system does not operate normally (passenger side)	1. Door window sliding part malfunction A foreign material adheres to window glass or glass run rubber. Glass run rubber wear or deformation. Sash is tilted too much, or no enough.
	2. Limit switch adjusting
	3. CHECK LIMIT SWITCH CIRCUIT (PASSENGER SIDE)
	4. CHECK ENCODER CIRCUIT (PASSENGER SIDE)
Power window retained power operation does not operate properly	Check the retained power operation mode setting.
	2. CHECK DOOR SWITCH
	3. Replace BCM.
Does not operate by key cylinder switch	1. CHECK DOOR KEY CYLINDER SWITCH
Does not operate by key cylinder switch	2. Replace power window main switch
Power window lock switch does not function	CHECK POWER WINDOW LOCK SWITCH
Auto operation does not operate but manual operates normally (driver side)	1. CHECK ENCODER CIRCUIT (DRIVER SIDE)
	2. Replace power window main switch.
Auto operation does not operate but manual operates normally (passenger side)	1. CHECK ENCODER CIRCUIT (PASSENGER SIDE)
	2. Replace front power window switch (passenger side)