Check Front Power Window Switch (Passenger Side) Power Supply and Ground Circuit

CHECK POWER SUPPLY CIRCUIT
Check voltage between front power window switch (passenger side) connector D36 terminal 10 and ground.

10 (W) - Ground : Battery voltage

Fig 1: Identifying Voltage Between Front Power Window Switch Connector D36 Terminal 10 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK : GO TO 2.

NG : GO TO 3.
CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front power window switch (passenger side) connector.
3. Check continuity between front power window switch (passenger side) connector D36 terminal 11 and ground.
  11 (B) - Ground : Continuity should exist.
  
  Fig 2: Identifying Continuity Between Front Power Window Switch Connector D36 Terminal 11 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK : Front power window switch (passenger side) power supply and ground circuit are OK.

NG : Repair or replace harness.
CHECK HARNESS CONTINUITY
1. Disconnect BCM connector.
2. Check continuity between BCM connector M4 terminal 54 and front power window switch (passenger side) connector D36 terminal 10.
  54 (W) - 10 (W) : Continuity should exist.
3. Check continuity between BCM connector M4 terminal 54 and ground.
  54 (W) - Ground : Continuity should not exist.
  
  Fig 3: Identifying Continuity Between BCM Connector M4 Terminal 54 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

OK : Check condition of harness and connector.

NG : Repair or replace harness.