Check Front Power Window Motor (Passenger Side) Circuit

1. Turn ignition switch ON.
2. Check voltage between front power window switch (passenger side) connector and ground.
   TERMINALS VOLTAGE CHART
   
   

   Connector	Terminals (Wire color)		Window condition	Voltage [V] (Approx.)
   	(+)	(-)
   D36	8 (L)	Ground	UP	Battery voltage
   			DOWN	0
   	9 (G)		UP	0
   			DOWN	Battery voltage

   Fig 1: Identifying Voltage Between Front Power Window Switch Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK : GO TO 2.

NG : Replace front power window switch (passenger side).

1. Turn ignition switch OFF.
2. Disconnect front power window switch (passenger side) and front power window motor (passenger side) connector.
3. Check continuity between front power window switch (passenger side) connector D36 terminals 8, 9 and front power window motor (passenger side) connector D38 terminals 1, 2.

   8 (L) - 2 (L) : Continuity should exist. 

   9 (G) - 1 (G) : Continuity should exist. 

   Fig 2: Identifying Continuity Between Front Power Window Switch Terminals 8, 9 And Front Power Window Motor Terminals 1, 2

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK : Replace front power window motor (passenger side).

NG : Repair or replace harness.