Front Fender Replacement

Fig 1: Front Fender

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the front wheelhouse opening flare. Refer to Front Wheel Opening Flare Replacement (Base) or Front Wheel Opening Flare Replacement (with BRM and RHD) . Remove the front wheelhouse panel. Refer to Wheelhouse Panel Replacement (Front) or Wheelhouse Panel Replacement (Rear) . Remove the rocker panel molding. Refer to Rocker Panel Molding Replacement . Remove air inlet grille panel. Refer to Non-Functional Air Inlet Grille Panel Replacement .
1	Bolts, Front Fender (Qty: 2) Tighten: 10 N.m (89 lb in)
2	Bolt, Front Fender (Qty: 2) Tighten: 10 N.m (89 lb in)
3	Bolt, Front Fender (Qty: 3) Tighten: 10 N.m (89 lb in)
4	Fender, Front Fender Tip: On right side fender, remove the antenna mast. Refer to Fixed Antenna Mast Replacement .