LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Restraints >> Seat Belts >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear >> Removal Procedure

Removal Procedure

  1. Remove the door sill plate. Refer to Front Side Door Sill Plate Replacement or Rear Side Door Sill Plate Replacement .
  2. Remove the lower anchor bolt from bodyside panel.
  3. Remove the lock pillar trim panel. Refer to Center Pillar Lower Garnish Molding Replacement .
  4. Route the belt through trim panel.
    5. Fig 1: Upper Guide Bolt
    GM833563Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt from the upper guide.
  6. Remove the bolt from the retractor.
  7. Remove the seat belt anchor bolt cover.
  8. Remove the floor anchor bolt.
  9. Remove the assembly from the vehicle.
scientia non olet · About LEMON Manuals