Inflatable Restraint Passenger Presence System Replacement - Front

Fig 1: Inflatable Restraint Passenger Presence System - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedure: Remove the front seat. Refer to Front Seat Replacement - Bucket .
1	Front Seat Recliner Lever (If Equipped) Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
2	Front Seat Adjuster Outer Finish Cover Refer to Front Seat Cushion Outer Trim Panel Replacement .
3	Front Seat Adjuster Inner Finish Cover Refer to Front Seat Cushion Inner Trim Panel Replacement .
4	Front Seat Cushion Cover and Pad Tip: Disengage the j-channel retainers from the seat cushion frame. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
5	Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)
6	Inflatable Restraint Front Passenger Presence Sensor Procedure Lay the seat on its side. Unhook the connector from retainer on seat frame and push up through seat pan. Disconnect and remove the sensor.
7	Front Seat Adjuster Assembly Refer to Front Seat Adjuster Replacement .
8	Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2) Procedure: Drill out the rivets to remove and install using new rivets.
9	Inflatable Restraint Front Passenger Presence Module Tip: The inflatable restraint passenger presence module must be replaced as a kit that also includes the sensor assembly. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .