Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging .
- Remove the auxiliary A/C evaporator tubes (3) from the condenser tube (2) and the accumulator (5).
- Loosen the right front wheelhouse to gain access to the clamp behind the wheelhouse.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the right assist step. Refer to Assist Step Replacement (Manual) or Assist Step Replacement (Z71 ) or Assist Step Replacement (Power) .
- Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
- Remove the rear wheelhouse liner. Refer to Wheelhouse Liner Panel Replacement - Rear .
- Remove the retaining nut (2) and the auxiliary A/C evaporator tubes (3) from the auxiliary HVAC module.
- Remove the heater/A/C tubes retaining nut (4) from the stud (1) at the frame (6).
- Remove the auxiliary A/C evaporator tubes (3) from the clamps (5).
- Remove the auxiliary A/C evaporator tubes from the vehicle.