Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the auxiliary A/C evaporator tubes to the vehicle.
- Install the auxiliary A/C evaporator tubes (3) to the clamps (5).
- Install the heater/A/C tubes retaining nut (4) to the stud (1) at the frame (6).
Tighten: Tighten the nut to 7 N.m (62 lb in).
- Install the auxiliary A/C evaporator tubes (2, 3) and the retaining nut to the auxiliary HVAC module.
Tighten: Tighten the nut to 16 N.m (12 lb ft).
- Lower the vehicle.
- Install the rear wheelhouse liner. Refer to Wheelhouse Liner Panel Replacement - Rear .
- Install the right assist step. Refer to Assist Step Replacement (Manual) or Assist Step Replacement (Z71 ) or Assist Step Replacement (Power) .
- Install the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
- Install the auxiliary A/C evaporator tubes (3) to the condenser tube (2) and the accumulator (5).
Tighten: Tighten the nuts to 16 N.m (12 lb ft).
- Recharge the refrigerant to the system. Refer to Refrigerant Recovery and Recharging .
- Leak test the fittings of the component using the J 39400-A . See Special Tools .
NOTE:
Refer to Fastener Notice
.