Turn Signal Multifunction Switch Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turn Signal Multifunction Switch

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Remove the steering wheel. Refer to Steering Wheel Replacement . Remove the steering column shroud. Refer to Steering Column Shroud Replacement (With Electronic Tilt Steering) , Steering Column Shroud Replacement (Without Electronic Tilt Steering) .
1	Turn Signal Multifunction Switch Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 3 N.m (27 lb in)
2	Turn Signal Multifunction Switch Procedure NOTE: The wiper and washer switches are integral to the turn signal multifunction switch. Disconnect any electrical connectors as needed.

Callout

Component Name

WARNING:

Refer to SIR Warning .

Preliminary Procedure

Remove the steering wheel. Refer to Steering Wheel Replacement .
Remove the steering column shroud. Refer to Steering Column Shroud Replacement (With Electronic Tilt Steering) , Steering Column Shroud Replacement (Without Electronic Tilt Steering) .

Turn Signal Multifunction Switch Bolt (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
3 N.m (27 lb in)

Turn Signal Multifunction Switch
Procedure

NOTE:

The wiper and washer switches are integral to the turn signal multifunction switch.

Disconnect any electrical connectors as needed.