Seat Belt Retractor Replacement - No. 1 Rear Center (Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Center Belt Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove rear bench seat. Refer to Rear Seat Replacement (Tahoe with HP2) or Rear Seat Replacement (Avalanche/Escalade EXT) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) . Remove seat back pad and cover. Refer to Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Bucket) or Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Back Cushion Cover and Pad Replacement (Avalanche/Escalade EXT) .
1	Rear Seat Center Belt Assembly Cover Tip: Tilt 40 percent split forward for access.
2	Rear Seat Center Belt Retainer
3	Rear Seat Center Belt Bolt (Qty: 2) Tighten: 52 N.m (38 lb ft)
4	Rear Seat Center Belt Assembly