Section 1805 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle (1 Of 3))
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Draining Fluids and Oil Filter Removal
- Crankshaft Balancer Removal
- Engine Flywheel Removal
- Automatic Transmission Flex Plate Removal
- Clutch Pilot Bearing Removal
- Oil Level Indicator and Tube Removal
- Exhaust Manifold Removal - Left Side
- Exhaust Manifold Removal - Right Side
- Water Pump Removal
- Throttle Body Assembly Removal
- Fuel Rail and Injectors Removal
- Intake Manifold Removal (Without Active Fuel Management)
- Intake Manifold Removal (With Active Fuel Management)
- Engine Coolant Air Bleed Pipe and Hole Cover Removal
- Engine Block Valley Cover Removal
- Valve Lifter Oil Manifold Removal
- Valve Lifter Oil Filter Removal
- Valve Rocker Arm Cover Removal - Left Side
- Valve Rocker Arm Cover Removal - Right Side
- Valve Rocker Arm and Push Rod Removal
- Cylinder Head Removal - Left Side
- Cylinder Head Removal - Right Side
- Valve Lifter Removal (Without Active Fuel Management)
- Valve Lifter Removal (With Active Fuel Management)
- Oil Filter Removal
- Oil Pan Removal
- Engine Front Cover Removal
- Crankshaft Rear Oil Seal Housing Removal
- Oil Pump, Screen and Crankshaft Oil Deflector Removal
- Timing Chain, Crankshaft Sprocket, Camshaft Position Actuator, and Solenoid Valve Removal
- Camshaft Removal
- Piston, Connecting Rod, and Bearing Removal
- Crankshaft and Bearing Removal
- Engine Block Plug Removal
- Engine Block Cleaning and Inspection
- Cylinder Boring and Honing
- Crankshaft and Bearing Cleaning and Inspection
- Crankshaft Balancer Cleaning and Inspection
- Automatic Transmission Flex Plate Cleaning and Inspection
- Piston and Connecting Rod Disassemble
- Piston, Connecting Rod, and Bearing Cleaning and Inspection (Except L9H and L94)
- Piston, Connecting Rod, and Bearing Cleaning and Inspection (L9H and L94)
- Piston and Connecting Rod Assemble (Except L9H and L94)
- Piston and Connecting Rod Assemble (L9H and L94)
- Camshaft Bearing Removal
- Camshaft and Bearings Cleaning and Inspection
- Camshaft Bearing Installation
- Camshaft Timing Chain and Sprocket Cleaning and Inspection
- Camshaft Position Actuator Cleaning and Inspection
- Camshaft Position Actuator Magnet Cleaning and Inspection