LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1805 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle (1 Of 3)) >> Engine Block Valley Cover Removal

Engine Block Valley Cover Removal

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Engine Valley Cover
    GM1403316Courtesy of GENERAL MOTORS CORP.
  1. Remove the valley cover bolts (506).
  2. Remove the valley cover (555) and gasket (556).
  3. Remove the O-ring seals (537) from the cover.
    4. Fig 2: Removing/Installing Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil pressure sensor (706) and washer (707), as required.
scientia non olet · About LEMON Manuals