Installation Procedure
WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
- With the aid of an assistant, position the headliner trim panel assembly (1) into the vehicle through the liftgate opening.
- Connect the electrical connectors.
- Tape any unused connectors to the headlining with a high adhesive tape.
- Install the headliner trim panel retainers. (1)
- Install Windshield Multifunction Sensor Mount Bracket Cover (1) Windshield Multifunction Sensor Mount Bracket Cover Replacement (with UEU)Windshield Multifunction Sensor Mount Bracket Cover Replacement (without UEU)
- Install Roof Console (1) Roof Console Replacement
- Install Body Rear Corner Upper Garnish Molding (3) Body Rear Corner Upper Garnish Molding Replacement
- Install Quarter Window Trim Finish Panel (3) Quarter Window Trim Finish Panel Replacement
- Install Center Pillar Upper Trim Panel (1) Center Pillar Upper Trim Panel Replacement
- Install Windshield Garnish Molding (1) Windshield Garnish Molding Replacement
- Install 3rd Row Seat Position Center Reading and Courtesy Lamp (1) 3rd Row Seat Position Center Reading and Courtesy Lamp Replacement
- Install Rear Seat Position Center Reading and Courtesy Lamp (1) Rear Seat Position Center Reading and Courtesy Lamp Replacement
- Install Roof Rail Rear Assist Handle (2) Roof Rail Rear Assist Handle Replacement
- Install Active Noise Cancellation Microphone Grille (1) Active Noise Cancellation Microphone Grille Replacement
- Install Roof Rail Front Assist Handle (2) Roof Rail Front Assist Handle Replacement
- Install Sunshade Support (2) Sunshade Support Replacement
- Install Sunshade (3)Sunshade Replacement
- Enable the SIR System. SIR Disabling and Enabling