Body Rear Corner Upper Garnish Molding Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Body Rear Corner Upper Garnish Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Disable the SIR system. SIR Disabling and Enabling Remove the rear seat lower anchor plate bolt on the side of the trim panel being replaced. Rear Seat Belt Retractor Replacement
1	Body Rear Corner Upper Garnish Molding Cap
2	Body Rear Corner Upper Garnish Molding Fastener CAUTION: Refer to Fastener Caution . Tighten 3 N.m (27 lb in)
3	Body Rear Corner Upper Garnish Molding Procedure Use a flat bladed plastic trim tool. Route the seat belt through trim panel. Enable the SIR System. SIR Disabling and Enabling