Removal Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling (With J77) Parking Brake Cable Adjuster Disabling (Without J77)
- Remove the driver footrest. Refer to Driver Footrest Replacement (Sedan)Driver Footrest Replacement (Coupe) .
- Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement (Sedan)Front Side Door Sill Trim Plate Replacement (Coupe)
- Position the driver side front floor carpet and insulator aside to access the parking brake lever front cable pass through grommet.
- Disconnect the parking brake indicator switch electrical connector.
- Remove the parking brake lever rear nuts (1).
- Remove the parking brake lever forward nut (1).
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (ATS)Lifting and Jacking the Vehicle (ATS-V) .
- Remove the left side underbody front air deflector. Refer to Underbody Front Air Deflector Replacement - Left Side .
- Disconnect the parking brake lever front cable from the parking brake intermediate cable connector (1).
- Using the CH-37043 Parking Brake Cable Release Tool, release the parking brake lever front cable (1) from the underbody bracket.
- Release the parking brake lever front cable pass through grommet (1) from the driver floor panel.
- Remove the parking brake lever assembly.