Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer the rear side door inside handle cable. Refer to Rear Side Door Inside Handle Cable Replacement .
- Transfer the front side door outside handle cable. Refer to Front Side Door Outside Handle Cable Replacement (Sedan) Front Side Door Outside Handle Cable Replacement (Coupe) .
- Place the window in the full up position.
- Install the outside handle bracket (1) and the rear side door latch (2) assembly in the vehicle.
- Install four bolts (1) to the rear side door latch and tighten to 10 N.m (89 lb in).
- Install the rear side door outside handle bracket screw. Refer to Rear Side Door Outside Handle Bracket Replacement .
- Install the rear side door outside handle. Refer to Rear Side Door Outside Handle Replacement .
- Connect the rear side door latch electrical connector.
- Connect the electrical connector to the rear side door outside handle bracket for the luminous reflecting light, if equipped.
- Install the rear side door locking rod. Refer to Rear Side Door Locking Rod Replacement .
- Inspect the door latch and the outside handle for proper operation before install the door trim.
- Install the water deflector.
- Install the rear side door armrest plate bolts and plate to the inner door panel.
- Install the rear side door trim. Refer to Rear Side Door Trim Replacement .
CAUTION:
Refer to Fastener Caution .
NOTE:
Install and torque the four latch bolts in proper sequence to prevent damage to the latch mechanism.