Headlamp Replacement (Traverse with TVP)

Fig 1: Headlamp (Traverse With TVP)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Enclave) , Front Bumper Fascia Replacement (Acadia) , Front Bumper Fascia Replacement (Traverse) .
1	Fender Brace Bolt to Headlamp CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Headlamp Bolt Tighten 6 N.m (53 lb in)
3	Headlamp Horizontal and Vertical Adjusting Cam Nut Bolt (Qty: 2) Procedure Set the cam adjusting nuts to the nominal setting of 6 turns off fully seated prior to installing the new headlamp assembly. Check the front bumper fascia to headlamp finish fit and adjust the cam nuts accordingly to achieve an even fit.
4	Headlamp Assembly WARNING: Refer to Halogen Bulb Warning . Procedure Gently pull forward the headlamp assembly. Disconnect the forward lamp harness electrical connector from the headlamp assembly electrical connector. Remove the headlamp from vehicle. Transfer the headlamp electrical harness with bulb sockets as needed. Aim the headlamps. Refer to Headlamp Aiming .