Section 13 (Transfer Case - NVG 261-NP2 - Service & Troubleshooting)
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Transfer Case
- Symptoms - Transfer Case
- Four-Wheel Drive Does Not Disengage
- Four-Wheel Drive Does Not Engage
- 4WD Indicator Always On
- 4WD Indicator Inoperative
- Transfer Case Popping Noise
- Transfer Case Whine or Rumble Noise
- Transfer Case Growl or Grinding Noise
- Transfer Case Clunk in 2HI Only
- Transfer Case Clunk in 4HI
- Transfer Case Clunk in 4LO
- Transfer Case Shudder or Binding
- Transfer Case Will Not Shift
- Transfer Case Jumps Out of Gear
- Transfer Case Leak Diagnosis
- Repair Instructions
- Transfer Case Shield Replacement
- Transfer Case Fluid Replacement
- Transfer Case Speed Sensor Replacement
- Transfer Case Gear Indicator Switch Replacement
- Transfer Case Control Lever Replacement
- Transfer Case Control Rod Replacement
- Transfer Case Output Shaft Seal Replacement - Front
- Transfer Case Output Shaft Seal Replacement - Rear
- Transfer Case Assembly Replacement
- Transfer Case Input Shaft Seal Replacement
- Transfer Case Adapter Replacement
- Description and Operation
- Special Tools and Equipment