LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Transfer Case - NVG 261-NP2 - Service & Troubleshooting) >> Repair Instructions >> Transfer Case Control Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Before beginning the following service procedure, place a automatic transmission equipped vehicle into the PARK position, place a manual transmission equipped vehicle into FIRST GEAR. Then place the transfer case in the 2 HI position.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front .
    3. IMPORTANT: When performing this service procedure, use a small pocket screwdriver in order to release the retaining clip on the ends of the control rod.
    Fig 1: Removing Control Rod From Control Lever
    GM649764Courtesy of GENERAL MOTORS CORP.
  3. Remove the control rod from the control lever.
  4. Remove the control rod from the shift lever.
    Fig 2: Removing Control Rod From Shift Lever
    GM396830Courtesy of GENERAL MOTORS CORP.
  5. Remove the control rod.
scientia non olet · About LEMON Manuals