LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Transfer Case - NVG 261-NP2 - Service & Troubleshooting) >> Repair Instructions >> Transfer Case Control Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
  • Before installing a NEW control rod, loosen the adjusting bolt on the control rod so it slides with slight resistance.
  • When installing the control rod on the control levers, a snapping sound should be heard or felt upon installation.
  1. Install the control rod onto the control lever first.
    Fig 1: Installing Control Rod Onto Control Lever
    GM396830Courtesy of GENERAL MOTORS CORP.
  2. Slide the control rod forward.
  3. Install the control rod onto the shift control lever.
    Fig 2: Installing Control Rod Onto Shift Control Lever
    GM396831Courtesy of GENERAL MOTORS CORP.
    4. NOTE: Refer to FASTENER NOTICE .
    Fig 3: Tightening Transfer Case Control Rod Adjusting Bolt
    GM649765Courtesy of GENERAL MOTORS CORP.
  4. Tighten the control rod adjusting bolt.

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).

  5. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front .
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals