Rear Side Door Window Replacement (Crew Cab)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Door Window (Crew Cab)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (SLT) or Rear Side Door Trim Panel Replacement (YE9) . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement . Remove the rear door window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement (Crew Cab) or Rear Side Door Window Weatherstrip Replacement (Extended Cab) .
1	Rear Door Window Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure: Loosen the 2 bolts that attach the window to the window regulator. Tighten: 7 N.m (61 lb in)
2	Rear Door Window Tip: The window must be tilted downward into the door to remove it.

Callout

Component Name

Preliminary Procedures

Position the door window as needed for service.
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (SLT) or Rear Side Door Trim Panel Replacement (YE9) .
Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
Remove the rear door window weatherstrip. Refer to Rear Side Door Window Weatherstrip Replacement (Crew Cab) or Rear Side Door Window Weatherstrip Replacement (Extended Cab) .

Rear Door Window Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Procedure:
Loosen the 2 bolts that attach the window to the window regulator.

Tighten: 7 N.m (61 lb in)

Rear Door Window
Tip: The window must be tilted downward into the door to remove it.