Rear Side Door Trim Panel Replacement (SLT)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Trim Panel (SLT)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear door window control switch. Refer to Rear Side Door Window Switch Replacement (Crew Cab) or Rear Side Door Window Switch Replacement (Extended Cab) .
1	Rear Side Door Locking Rod Knob Assembly Procedure Lower the window. Ensure the locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push the knob down, until the detent tab touches locking rod opening cover. Push the detent tab in to lock knob to locking rod.
2	Rear Side Door Trim Panel Cover
3	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
4	Rear Side Door Inside Handle Bezel Cover
5	Rear Side Door Trim Panel Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (18 lb in)
6	Rear Side Door Trim Panel Assembly Procedure Disconnect the electrical connectors. There are 2 hooks located on the lower portion of the door trim panel that are being used for service and manufacturing installation. If these hooks are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.
7	Rear Side Door Cable Retainer Procedure Depress both tabs to remove cable and pull cable rearward out of handle assembly. When reinstalling cable make sure that it is fully seated past the guide tab.
8	Rear Side Door Trim Panel Retainer (Qty: 10)