Rear Side Door Window Weatherstrip Replacement (Extended Cab)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Window Weatherstrip (Extended Cab)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (SLT) or Rear Side Door Trim Panel Replacement (YE9) . Remove the rear door inner sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (Crew Cab) or Rear Side Door Window Inner Sealing Strip Replacement (Extended Cab) .
1	Rear Door Rear Window Weatherstrip Bolt CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Rear Door Rear Window Weatherstrip Procedure: After the bolt has been removed from the weatherstrip, pull downward to release it from the door.
3	Rear Door Front Window Weatherstrip Bolt Tighten: 10 N.m (89 lb in)
4	Rear Door Front Window Weatherstrip Procedure: After the bolt has been removed from the weatherstrip, pull downward to release it from the door.