Section 40 (Engine Controls - Pinpoint Test NB: Malfunction Indicator Lamp Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid))
WARNING: This page is about a different variant/trim than selected.
- Pinpoint Test NB: Malfunction Indicator Lamp
- Pinpoint Test NC: Ignition Engine Speed Input Circuit
- Pinpoint Test ND: Engine RPM\Vehicle Speed Limiter Reached
- Pinpoint Test QA: Unable to Activate Self-Test/Network Communication Error
- Pinpoint Test QB: DTCs P0603 or P1633: Keep Alive Power
- Pinpoint Test QC: DTC P1000: On-Board Diagnostic (OBD) Systems Readiness Test Not Complete
- Pinpoint Test QD: DTC P1260: Passive Anti-Theft System
- Pinpoint Test QE: Electronic Throttle Control (ETC) System
- Pinpoint Test TA: Clutch Pedal Position (CPP) Switch
- Pinpoint Test TB: Transmission Control Switch (TCS)/ Transmission Control Indicator Lamp (TCIL)
- Pinpoint Test TG: 4x4 Low Switch (4X4LSW) And Four Wheel Drive (4WD) Switch
- Pinpoint Test TJ: Output Shaft Speed (OSS) Sensor
- Pinpoint Test Z: Intermittent