LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Focus LX, Standard >> Repair and Diagnosis >> Transmission >> Automatic Transmission Diagnosis >> Diagnosis & Testing >> Reading Diagnostic Trouble Codes >> Continuous Memory Codes (Intermittent Faults)

Continuous Memory Codes (Intermittent Faults)

CAUTION: Continuous memory codes should be recorded when retrieved. These codes may be used to identify intermittent problems that exist after all KOEO and KOER DTCs have been repaired. Some continuous memory codes may not be valid after KOEO and KOER DTCs are serviced.

Continuous memory codes result from information stored by PCM during continuous self-test monitoring. Use these DTCs for diagnosis only when KOEO SELF-TEST and KOER SELF-TEST result in SYSTEM PASS and all steps under QUICK TEST are successfully completed. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table. After recording or repairing fault, clear DTCs from memory. See CLEARING DIAGNOSTIC TROUBLE CODES  . Intermittent faults may be caused by a faulty sensor, connector or wiring.

DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC Definition (1) System Test
P0705 Transmission Range Sensor Fault C 
P0712, P0713 & P1783 Transmission Fluid Temperature Sensor Fault B 
P0715 & P0717 Turbine Shaft Speed Sensor Fault E 
P0720, P0721 & P0722 Output Shaft Speed Sensor Fault E 
P0731 1st Gear Error A 
P0732 2nd Gear Error A 
P0733 3rd Gear Error A 
P0734 4th Gear Error A 
P0741 Torque Converter Slippage Detected (2)
P0745 PCA (EPC) Solenoid Fault D 
P0750 Shift Solenoid "A" (SSA) Circuit Fault A 
P0751 Shift Solenoid "A" (SSA) Fault (3)
P0755 Shift Solenoid "B" (SSB) Circuit Fault A 
P0756 Shift Solenoid "B" (SSB) Fault (3)
P0760 Shift Solenoid "C" (SSC) Circuit Fault A 
P0761 Shift Solenoid "C" (SSC) Fault A 
P0765 Shift Solenoid "D" (SSD) Circuit Fault A 
P0766 Shift Solenoid "D" (SSD) Fault A 
P0770 Shift Solenoid "E" (SSE) Circuit Fault A 
P0771 Shift Solenoid "E" (SSE) Fault A 
P1605 A/T Data Communication Line Fault (3)
P1700 Transaxle Mechanical Failure (3)
P1705 Transmission Range Sensor Not In Park/Neutral During KOEO/KOER (4)C 
P1711, P1713 & P1718 Transmission Fluid Temperature Sensor Fault B 
P1714, P1715, P1716, P1717 & P1740 Solenoid Mechanical Failure F 
P1746, P1747 & P1760 PCA (EPC) Solenoid Circuit Fault D 
P1780 Transmission Control Switch Input Incorrect For Selected Position (5)
(1) For diagnostic procedures, see SYSTEM TESTS  .
(2) See SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
(3) See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
(4) Perform KOEO/KOER self test in Park or Neutral.
(5) Perform OBD tests and cycle transmission control switch. See QUICK TEST  .
scientia non olet · About LEMON Manuals