LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Camshaft >> Installation

Removal & Installation: Camshaft: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat camshaft lobes with multipurpose grease. Coat bearing journals with clean engine oil. Install Woodruff key, spacer and thrust plate on camshaft. Align gear keyway with key and install gear using Camshaft Gear Replacing Adapter (T65L-6306-A).
  2. Install camshaft, spacer, thrust plate and gear as an assembly, ensuring timing marks are aligned. See Figure. Tighten thrust plate bolts. Ensure camshaft end play is within specification. See CAMSHAFT  table under ENGINE SPECIFICATIONS.
  3. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Fill and bleed air from cooling system. See COOLING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals