LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Cooling System Bleeding

Cooling System Bleeding

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. To bleed trapped air from cooling system, disconnect heater hose from water pump. Using 50/50 mixture of coolant and water, fill radiator until coolant flows from heater hose fitting at water pump. Reconnect heater hose.
  2. Fill radiator until coolant is 1.5" (38 mm) below radiator cap seal. Install radiator cap. Run engine until warm. Turn off engine. CAREFULLY remove radiator cap and check level. Fill as required.
scientia non olet · About LEMON Manuals