LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Exterior) >> Left Front Fender >> Installation

Left Front Fender: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position fender and wheelhouse from vehicle.
  2. Install bolts attaching fender to upper radiator closure panel and tighten to 16 N.m (12 ft. lbs.).
  3. Install bolts attaching fender to upper cowl and tighten to 28 N.m (21 ft. lbs.).
    Fig 1: Removing/Installing Bolts Attaching Fender To Upper Cowl
    G02655714Courtesy of DAIMLERCHRYSLER CORP.
  4. Install bolts attaching fender to hood hinge support bracket and tighten to 28 N.m (21 ft. lbs.).
  5. Install bolts attaching fender to lower radiator closure panel and tighten to 17 N.m (13 ft. lbs.).
  6. Install bolt attaching fender to lower rocker panel and tighten to 28 N.m (21 ft. lbs.).
  7. Position the hood release cable to inner fender and engage clips.
  8. Position the wire harnesses on the inner fender and wheelhouse and engage clips.
  9. Install HCU if equipped. (Refer to INSTALLATION )
  10. Install battery support bracket and battery tray. (Refer to INSTALLATION (2003) or BATTERY TRAY (2004))
  11. Install left headlamp module. (Refer to INSTALLATION (2003) or HEADLAMP (2004))
  12. Install wheelhouse liner. (Refer to BODY/EXTERIOR/FRONT END SPLASH SHIELDS-INSTALLATION  )
  13. Install wheel opening molding. (Refer to BODY/EXTERIOR/WHEEL OPENING MOLDING-INSTALLATION  )
  14. Install left front wheel. (Refer to STANDARD PROCEDURE )
scientia non olet · About LEMON Manuals