Right Lower Instrument Panel Trim: Installation
WARNING: This page is about a different car, the 2005 Dodge Stratus and 2005 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
- Install new right lower trim panel onto instrument panel beam assembly.
- Attach five screws around glove box opening. Note the lower right hand screw must be installed first to properly align glove box door.
- Attach one screw on right outboard end.
- Attach two screws above glove box door opening.
- Attach two screws below radio opening.
- Attach three screws along left end of panel.
- Install glove box assembly (Refer to BODY/INSTRUMENT PANEL/GLOVE BOX - INSTALLATION) .
- Install right a/c housing and attach with three screws. Note the two upper screw attachments use the pan head screws and the bottom attachment uses the hex head screw.
- Attach right a/c barrel.
- Install radio and attach.
- Install CD bracket, CD player, and CD trim bezel (if so equipped) (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) .
- Install instrument panel cluster bezel (Refer to BODY/INSTRUMENT PANEL/CLUSTER BEZEL - INSTALLATION) .
- Install outboard, inboard, and right trim bezels (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION) (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION)
- Install center bezel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - INSTALLATION)
- Install left lower instrument panel trim (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TRIM - INSTALLATION)
- Install right and left instrument panel end covers (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL END CAP - INSTALLATION)
- Install instrument panel kick shield (Refer to BODY/INSTRUMENT PANEL/KNEE BLOCKER - INSTALLATION) .
- Install console assembly (Refer to BODY/INTERIOR/FLOOR CONSOLE - INSTALLATION)
- Reconnect battery.