LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Cylinder Head >> Valve Springs >> Removal & Installation >> Removal (In Vehicle)

Removal (In Vehicle)

  1. Perform fuel system pressure release procedure before attempting any repairs.
  2. Disconnect negative cable from remote jumper terminal.
  3. Remove air cleaner housing and inlet hose.
  4. Remove upper intake manifold. See REMOVAL - UPPER INTAKE MANIFOLD .
  5. Remove cylinder head covers. See CYLINDER HEAD COVER - LEFT  and CYLINDER HEAD COVER - RIGHT  .
  6. Remove crankshaft vibration damper, timing chain cover and timing chain. See REMOVAL - TIMING CHAIN .
  7. Remove camshafts and rocker arms. REMOVAL .
  8. With air hose attached to spark plug adapter installed in the cylinder being serviced, apply 620.5-689 kPa (90-100 psi) air pressure. This is to hold valves in place while servicing components.
  9. Using Special Tool MD 998772A with adapter 6779, compress valve spring and remove valve locks, retainer, and valve spring.
  10. Remove valve stem seal. See REMOVAL .
scientia non olet · About LEMON Manuals