LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L V6 Engine - VIN U >> Manifolds >> Intake Manifold >> Removal & Installation >> Removal - Upper Intake Manifold

Removal - Upper Intake Manifold

  1. Disconnect negative battery cable.
  2. Remove throttle body air inlet hose and air cleaner housing assembly.
  3. Remove throttle cable shield. Remove throttle and speed control cables from throttle arm and bracket.
  4. Remove throttle cable bracket.
  5. Disconnect electrical connectors from the following components:
    • Manifold Absolute Pressure (MAP)
    • Sensor Throttle Position Sensor (TPS)
    • Sensor Idle Air Control (IAC)
    • Motor Manifold Tuning Valve (MTV)
  6. Disconnect Vapor Purge hose, Brake Booster hose, Speed Control Servo, Positive Crankcase Ventilation (PCV) hose.
  7. Remove EGR upper tube.
  8. Loosen upper fastener at throttle body support bracket.
  9. Remove manifold attaching bolts.
    Fig 1: Removing Manifold Attaching Bolts (Upper)
    G00386005Courtesy of CHRYSLER CORP.
  10. Remove upper manifold.
    Fig 2: Removing Upper Manifold
    G00386006Courtesy of CHRYSLER CORP.
  11. Inspect manifold.
scientia non olet · About LEMON Manuals