LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> Test 10A: Orc, Driver Squib 1 Circuit Short (Active Code)

Test 10A: Orc, Driver Squib 1 Circuit Short (Active Code)

NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform TEST VER-1: AIR BAG VERIFICATION TEST  after all repairs unless otherwise directed.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove driver-side air bag module. See OCCUPANT RESTRAINT CONTROLLER (ORC)  under REMOVAL & INSTALLATION. Connect SRS Load Tool (8310) Brown cable and appropriate jumper to clockspring side of clockspring-to-air bag module connector. Connect DRB to DLC. Turn ignition switch to ON position. Connect negative battery cable. On DRB display, read active air bag DTCs. If DRB displays DRIVER SQUIB 1 CIRCUIT SHORT, go to next step. If DRB does not display DRIVER SQUIB 1 CIRCUIT SHORT, replace driver-side air bag module.
  2. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access and disconnect clockspring lower connector. See CLOCKSPRING  under REMOVAL & INSTALLATION. Connect SRS Load Tool (8310) Black cable and appropriate jumper to harness side of clockspring lower connector. Turn ignition switch to ON position. Connect negative battery cable. On DRB display, read active air bag DTCs. If DRB displays DRIVER SQUIB 1 CIRCUIT SHORT, go to next step. If DRB does not display DRIVER SQUIB 1 CIRCUIT SHORT, replace clockspring.
  3. Turn ignition switch to OFF position. Disconnect negative battery cable and wait at least 2 minutes. Access and disconnect ORC connector. See OCCUPANT RESTRAINT CONTROLLER (ORC)  under DESCRIPTION & OPERATION. Connect SRS Load Tool (8310) ORC adapter to harness side of ORC connector. Measure resistance between Dark Green-Light Blue and Black-Light Blue wires on harness side of clockspring lower connector. See WIRING DIAGRAMS  . If resistance is less than 5 ohms, repair short circuit between Dark Green-Light Blue and Black-Light Blue wires. If resistance is more than 5 ohms and no other malfunctions are detected, replace ORC.
scientia non olet · About LEMON Manuals