Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Brake and Accelerator Pedal Assembly (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake and Accelerator Pedal Assembly Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Brake and Accelerator Pedal Assembly Nut (1) - Install and tighten 9 N.m (80 lb in)
Courtesy of GENERAL MOTORS COMPANY

Steering Column (1) - Install - Steering Column Replacement
Courtesy of GENERAL MOTORS COMPANY

Upper Intermediate Steering Shaft (3) - Install - Upper Intermediate Steering Shaft Replacement
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Retainer (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal (1) - Connect
Ensure the locking tabs on the brake pedal retainer are fully engaged in the brake pedal (1) the retainer is attached securely to the brake push rod.
Courtesy of GENERAL MOTORS COMPANY

Wiring Harness Retainer (3) - Secure [2x]
Brake Pedal Position Sensor Electrical Connector (2) - Connect
Accelerator Pedal Position Sensor Electrical Connector (1) - Connect
Floor Front Air Outlet Duct - Left Side - Install - Floor Front Air Outlet Duct Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Power Brake Booster Bolt (1) - Install [2x] - Power Brake Booster Replacement
Radiator Surge Tank - Install - Radiator Surge Tank Replacement (LTG) , or Radiator Surge Tank Replacement (LKN) , or Radiator Surge Tank Replacement (LFV)