Installation Procedure

WARNING: This page is about a different car, the 2019 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Install a NEW seal.

Brake Master Cylinder Seal (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Master Cylinder (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

NOTE:
Install NEW nuts.

Master Cylinder Nut (1) - Install and tighten55 N.m (41 lb ft) [2x]
Courtesy of GENERAL MOTORS COMPANY

Master Cylinder Primary Brake Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Master Cylinder Secondary Brake Pipe Fitting (1) - Install and tighten 32 N.m (24 lb ft)
Connect the brake fluid level sensor electrical connector.
Radiator Surge Tank Replacement (LTG) , or Radiator Surge Tank Replacement (LKN) , or Radiator Surge Tank Replacement (LFV) - Install
Bleed the brake system. Hydraulic Brake System Bleeding (Pressure) , or Hydraulic Brake System Bleeding (Manual)