Installation Procedure
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air conditioning evaporator hose assembly.NOTE: Use NEW sealing washers.
- Install the air conditioning evaporator hose assembly nut (1) to air conditioning compressor and tighten to 22 N.m (16 lb ft)
- Clip the air conditioning evaporator hose assembly clips (1) to the hose assembly.
- Install the air conditioning evaporator hose assembly mounting bracket nut (2) and tighten to 6 N.m (53 lb in)
- Install the air conditioning evaporator hose assembly nut (1) to air conditioning evaporator thermal expansion valve and tighten to 22 N.m (16 lb ft).
- Check the A/C evaporator hose assembly (1) routing.
- Connect the A/C refrigerant pressure sensor electrical connector.
- Install the air conditioning compressor tube. Refer to Air Conditioning Compressor Tube Replacement .
- Install the intake air duct resonator. Refer to Intake Air Duct Resonator Replacement .
- Install the air cleaner inlet duct to the air cleaner outlet resonator. Refer to Air Cleaner Inlet Duct Replacement .
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (LV7) .
- Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Install the headlamp. Refer to Headlamp Replacement (Projection/SBV)Headlamp Replacement (BASE/SBM) .
- Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .
- Charge the refrigerant. Refer to Refrigerant Recovery and Recharging (R-134a) Refrigerant Recovery and Recharging (R-1234yf) .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .