Front End Upper Tie Bar Replacement

Preliminary Procedures

1. Remove the front bumper fascia center support. Refer to Front Bumper Fascia Center Support Replacement .
2. Remove the hood primary and secondary latch. Refer to Hood Primary and Secondary Latch Replacement .
3. Remove the upper radiator bracket bolts only. Refer to Radiator Upper Bracket Replacement
4. Reposition the hood latch cable from the front end upper tie bar.
5. Disconnect and unclip the wiring harness from the tie bar.
6. Remove the front end inflatable restraint discriminating sensors. Refer to Airbag Front End Discriminating Sensor Replacement