LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L (LUZ) Diesel) >> Repair Instructions - On Vehicle >> Engine Mount Inspection

Engine Mount Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Install the engine support fixture. Refer to Engine Support Fixture .
  2. Observe the engine mount while raising the engine. Raising the engine removes the weight from the engine mount and creates slight tension on the rubber.
  3. Replace the engine mount if the engine mount exhibits any of the following conditions:
    • The hard rubber is covered with heat check cracks.
    • The rubber is separated from the metal plate of the engine mount.
    • The rubber is split through the center of the engine mount.
  4. For engine mount replacement, refer to Engine Mount Replacement .
  5. For transmission front mount replacement, refer to Transmission Front Mount Replacement .
  6. For transmission rear mount replacement, refer to Transmission Rear Mount Replacement .
  7. For transmission mount replacement - left side, refer to Transmission Mount Replacement - Left Side .