Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install air conditioning condenser hose assembly into the vehicle.
- Install the air conditioning refrigerant pressure sensor. Refer to Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (LUV) .
- Install NEW air conditioning sealing washer (3) to the air conditioning condenser hose assembly.
- Install the air conditioning condenser hose assembly (2) to the air conditioning compressor assembly.
- Install air conditioning condenser hose assembly bolt (1) and tighten the bolt to 22 N.m (16 lb ft).
- Install NEW air conditioning sealing washers (3) to the air conditioning condenser hose assembly.
- Install the air conditioning condenser hose assembly (2) to the air conditioning condenser.
- Install the air conditioning condenser hose assembly nut (1) and tighten the nut to 22 N.m (16 lb ft).
- Install the front fascia assembly. Refer to Front Bumper Fascia Replacement (Trax)Front Bumper Fascia Replacement (Encore) .
- Install NEW air conditioning sealing washer (2) to the air conditioning condenser hose assembly.
- Install the air conditioning condenser hose assembly (1) to the evaporator hose assembly.
- Install the air compressor hose assembly to the air conditioning condenser hose assembly (1). Refer to Air Conditioning Compressor Hose Replacement (LUV) .
- Connect the A/C refrigerant pressure sensor electrical connector.
- Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
- Charge the refrigerant system. Refer to Refrigerant Recovery and Recharging (R-134a) .
NOTE:
Install NEW air conditioning sealing washers to the air conditioning condenser hose assembly. Refer to Air Conditioning System Seal Replacement .
CAUTION:
Refer to Fastener Caution .