LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Engine Cooling System) >> Repair Instructions >> Water Outlet Replacement (LUV) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the sealing surfaces.
    2. Fig 1: Water Outlet
    GM2192300Courtesy of GENERAL MOTORS COMPANY
  2. Install the water outlet (2) and a NEW water outlet seal ring (1).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the 3 water outlet bolts (3) and tighten to 8 N.m (71 lb in).
  4. Connect the engine coolant temperature sensor (water outlet) wiring harness connector.
  5. Install the engine oil cooler coolant inlet hose to the water outlet. Refer to Engine Oil Cooler Coolant Inlet Hose Replacement (LUJ) .
  6. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement (LUV) .
  7. Install the heater inlet hose to the water outlet. Refer to Heater Inlet Hose Replacement (LUV) .
  8. Install the engine coolant air bleed hose to the water outlet. Refer to Engine Coolant Air Bleed Hose Replacement (LUV) .
  9. Install the charge air cooler outlet air hose to the throttle body. Refer to Charge Air Cooler Outlet Air Hose Replacement .
  10. Fill the cooling system. Refer to Cooling System Draining and Filling .
scientia non olet · About LEMON Manuals