LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release air pressure from cylinder 3.
  2. Remove the EN-6086-15  pneumatic adapter.
  3. Remove all parts of EN-50716  spring and wedge replacer.
  4. Shift to neutral gear and release the park brake.
  5. Adjust the engine to TDC of cylinder 1 and fix the crankshaft with EN-952  fixing pin.
  6. Install the spark plugs. Refer to Spark Plug Replacement .
  7. Install the hydraulic valve lash adjuster arms. Refer to Hydraulic Valve Lash Adjuster Arm Replacement .
  8. Raise the vehicle.
  9. Remove the EN-952  fixing pin and install the crankshaft bearing cap tie plate hole plug. Refer to Camshaft Timing Chain Adjustment .
  10. Install the front wheelhouse liner . Refer to Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick) .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals