LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Camaro LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 6.2L (L99 LS3 LSA) Or 7.0L (LS7) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Drive Belt Tensioner Diagnosis

Drive Belt Tensioner Diagnosis

WARNING: This page is about a different variant/trim than selected.
CAUTION:

Allowing the drive belt tensioner to snap into the free position may result in damage to the tensioner.

NOTE:

When the engine is operating, the belt tensioner arm will move. Do not replace the belt tensioner because of movement in the belt tensioner arm.

  1. Remove the drive belt. Refer to Drive Belt Replacement - Accessory (LSA)Drive Belt Replacement - Accessory (Except LSA)Drive Belt Replacement - Accessory (LS7) .
  2. Position a hex-head socket on the belt tensioner pulley bolt.
  3. Move the belt tensioner through its full travel.
    • The movement should feel smooth.
    • There should be no binding.
    • The belt tensioner should return freely.
  4. If any binding is observed, replace the drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Accessory (L99, LS3)Drive Belt Tensioner Replacement - Accessory (L99, LS3, LS7)Drive Belt Tensioner Replacement - Accessory (LSA)
  5. Install the drive belt. Refer to Drive Belt Replacement - Accessory (LSA)Drive Belt Replacement - Accessory (Except LSA)Drive Belt Replacement - Accessory (LS7) .
scientia non olet · About LEMON Manuals