Ignition Key Cannot Be Removed from the Ignition Lock Cylinder
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify the key cannot be removed from the ignition lock cylinder. Is the key stuck in the lock cylinder? |
Go to Step 3 | System OK |
| 3 | Is the vehicle equipped with a manual transmission? | Go to Step 8 | Go to Step 4 |
| 4 | Turn the ignition key to the OFF position. Can the key be turned to the OFF position and be removed? |
Go to Step 8 | Go to Step 5 |
| 5 | Verify the adjustment of the automatic transmission shift cable. Refer to Shift Control Cable Adjustment
. Can the key be turned to the OFF position and be removed? |
System OK | Go to Step 6 |
| 6 | Inspect the lock cylinder solenoid plunger and spring. Does the plunger or spring exhibit scratches or signs of wear? |
Go to Step 10 | Go to Step 7 |
| 7 | Verify the electrical operation of the ignition lock cylinder solenoid. Refer to Ignition Can/Cannot Be Turned Off with Transmission in Any Gear . Can the key be turned to the OFF position and be removed? |
System OK | Go to Step 8 |
| 8 | Inspect for a faulty lock cylinder. Is the lock cylinder damaged? |
Go to Step 11 | Go to Step 9 |
| 9 | Inspect the ignition lock cylinder case. Is the case worn, damaged or loose? |
Go to Step 12 | Go to Step 13 |
| 10 | Replace the ignition lock cylinder solenoid and spring. Refer to Ignition Lock Cylinder Control Solenoid Replacement
. Did you complete the repair? |
Go to Step 13 | - |
| 11 | Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement
. Did you complete the repair? |
Go to Step 13 | - |
| 12 | Replace the ignition lock cylinder case housing. Refer to Ignition Lock Cylinder Case Replacement
. Did you complete the repair? |
Go to Step 13 | - |
| 13 | Operate the system to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |