LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Precautions and Procedures >> Disconnecting System Connectors

Disconnecting System Connectors

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.

    3. Driver's Airbag 

  3. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel (see SPRING-LOADED LOCK CONNECTOR ).
    Fig 1: Identifying Access Panel From Steering Wheel
    G06432098Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Front Passenger's Airbag 

  4. Lower the glove box (see step 1 GLOVE BOX STRIKER REPLACEMENT ). Disconnect the front passenger's airbag 4P connector (A) from the dashboard wire harness (B) (see SPRING-LOADED LOCK CONNECTOR ).
    Fig 2: Identifying Front Passenger's Airbag 4P Connector From Dashboard Wire Harness
    G06432099Courtesy of AMERICAN HONDA MOTOR CO., INC.

    5. Side Airbag 

  5. Disconnect both side airbag 2P connectors (A) from the floor wire harness (see SPRING-LOADED LOCK CONNECTOR ).
    Fig 3: Identifying Both Side Airbag 2P Connectors
    G06432100Courtesy of AMERICAN HONDA MOTOR CO., INC.

    6. Side Curtain Airbag 

  6. Remove the C-pillar trim (see C-PILLAR TRIM ).
  7. Disconnect both wire harness 2P connectors (A) from the side curtain airbags (see SPRING-LOADED LOCK CONNECTOR ).
    Fig 4: Identifying Both Wire Harness 2P Connectors
    G06432101Courtesy of AMERICAN HONDA MOTOR CO., INC.

    8. Seat Belt Tensioner 

  8. Remove the B-pillar lower trim (see B-PILLAR UPPER/LOWER TRIM ).
  9. Disconnect both floor wire harness 4P connectors (A) from the seat belt tensioners (see SPRING-LOADED LOCK CONNECTOR ).
    Fig 5: Identifying Both Floor Wire Harness 4P Connectors
    G06432102Courtesy of AMERICAN HONDA MOTOR CO., INC.

    10. SRS Unit 

  10. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
  11. Remove the heater joint duct (see step 7 DASHBOARD/STEERING HANGER BEAM REMOVAL/INSTALLATION ).
  12. Disconnect SRS unit connectors A (39P) and B (39P) from the SRS unit (see LEVER-LOCKED CONNECTOR ).
    Fig 6: Identifying SRS Unit Connectors A (39P) And B (39P)
    G06432103Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals