Glove Box Striker Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

NOTE: Take care not to scratch the dashboard and its related parts.

While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them in, then lower the glove box.

Fig 1: Releasing Glove Box Stops
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then remove the glove box striker (A).

Fig 2: Identifying Glove Box Striker And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the glove box striker in the reverse order of removal.