LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt
    GM1600754Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The drive belt tensioner is a hydraulic tensioner with high initial torque. Release slowly to ensure proper operation.
  1. Using an open end wrench, rotate the drive belt tensioner counter clockwise to release the spring tension.
  2. Remove the drive belt from around the tensioner.
  3. Remove the right front fender liner. Refer to Front Fender Liner Replacement .
  4. Remove the engine splash shield. Refer to Splash Shield Replacement - Engine .
  5. Remove the drive belt from around all the other pulleys.
  6. Remove the drive belt from the vehicle.
scientia non olet · About LEMON Manuals