LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1961 (Hybrid Controls - 3.6L (Hp5) - Introduction) >> Repair Instructions >> Generator Control Module 3-Phase Cable Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive motor/generator power inverter module cable 3 phase assembly "B".
  2. Install the 3 phase cable to stator bolts.
  3. Install the cable to case retaining bolts.
  4. Install the case cover. Refer to Case Cover Assembly Installation .
  5. Install the drive motor/generator power inverter module cable 3 phase assembly "A".
  6. Install the 3 phase cable to stator bolts.
  7. Install the cable to case retaining bolts.
  8. Install the torque dampener and differential housing assembly. refer to Torque Dampener and Differential Housing with Fluid Pump Installation .
  9. Install the torque dampener. Refer to Torque Dampener Installation .
  10. Install the transaxle in the vehicle. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals