LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1949 (Engine Cooling System) >> Repair Instructions >> Radiator Inlet Hose Replacement (HP5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Radiator Inlet Hose
    GM2154430Courtesy of GENERAL MOTORS CORP.
    NOTE: Lubricate the inside diameters of the hoses with clean coolant prior to installation.
  1. Install the inlet radiator hose into the vehicle.
  2. UsingJ 38185:  Hose Clamp Pliers disengage the tension on the hose clamp and install the radiator inlet hose to the engine.
    3. Fig 2: Radiator Inlet Hose & Clamp
    GM2154431Courtesy of GENERAL MOTORS CORP.
  3. Using J 38185:  Hose Clamp Pliers disengage the tension on the hose clamp and Install the radiator inlet hose to the radiator.
  4. Install the radiator vent inlet hose from the radiator inlet hose. Refer to Radiator Vent Inlet Hose Replacement (HP5) 
  5. Install the front end guard. Refer to Front End Guard Replacement 
  6. Install the radiator opening upper cover. Refer to Radiator Opening Upper Cover Replacement
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (LCS)
  8. Fill the coolant. Refer to Cooling System Draining and Filling (Static Fill With HP5)  or Cooling System Draining and Filling (GE 47716 Fill With HP5) 
scientia non olet · About LEMON Manuals