Assemble Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Engine Block Oil Gallery Plug Cap (1) - Install [ 2x ]

CAUTION:

NOTE:

Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant

Engine Block Oil Gallery Plug M16 (2) - Install and tighten [ 2x ] 40 N.m (30 lb-ft)
Cylinder Head Locating Pin (3) - Install [ 2x ]
Knock Sensor (4) - Install
Knock Sensor Bolt (5) - Install - Knock Sensor Replacement - Bank 2
Engine Oil Pressure Sensor (6) - Install - Engine Oil Pressure Sensor Replacement
Engine Block Core Hole Plug (7) - Install and tighten 45 N.m (33 lb-ft)
Engine Block Oil Gallery Plug M16 (8) - Install and tighten 40 N.m (30 lb-ft)
Piston Oil Nozzle (9) - Install [ 3x ]
Piston Oil Nozzle Bolt (10) - Install and tighten [ 3x ] 10 N.m (89 lb/in)
Engine Front Cover Stud (11) - Install and tighten [ 3x ] 15 N.m (11 lb-ft)
Courtesy of GENERAL MOTORS COMPANY

Cylinder Head Locating Pin (1) - Install [ 2x ]
Engine Block Core Hole Plug (2) - Install and tighten [ 2x ] 40 N.m (30 lb-ft)
Crankshaft Position Sensor (3) - Install
Crankshaft Position Sensor Bolt (4) - Install - Crankshaft Position Sensor Replacement
Knock Sensor (5) - Install
Knock Sensor Bolt (6) - Install - Knock Sensor Replacement - Bank 1
Knock Sensor Heat Shield (8) - Install
Knock Sensor Heat Shield Bolt (7) - Install and tighten [ 2x ] 10 N.m (89 lb/in)
Engine Block Oil Gallery Plug M16 (9) - Install and tighten [ 2x ] 40 N.m (30 lb-ft)
Engine Coolant Heater (10) - Install and tighten [ 2x ] 9 N.m (80 lb/in)
Crankshaft Rear Oil Seal Housing Locating Pin (11) - Install [ 2x ]
Engine Block Oil Gallery Plug M16 (12) - Install and tighten [ 2x ] 40 N.m (30 lb-ft)