Knock Sensor Replacement - Bank 2

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Compressor Air Intake Turbocharger Replacement - Left Side Starter Heat Shield Replacement (LGY)
1	Knock Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb-ft)
2	Knock Sensor Procedure Disconnect the electrical connector.

Callout

Component Name

Preliminary Procedures

Knock Sensor Bolt

CAUTION:

Tighten
25 N.m (18 lb-ft)

Knock Sensor
Procedure
Disconnect the electrical connector.