Rear Seat Back Cushion Cover & Pad Replacement (Avalanche/Escalade EXT)

Fig 1: View Of Rear Seat Back Cushion Cover, Pad & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure:  Remove the rear seat. Refer to Rear Seat Replacement (Tahoe with HP2)  or Rear Seat Replacement (Avalanche/Escalade EXT)  or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench)  or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) .
1	Rear Seat Back Trim Panel Refer to Rear Seat Back Cushion Trim Panel Replacement (Avalanche/Escalade EXT) .
2	Rear Seat Head Restraint Tip:  Depress the button on the inboard head restraint guide to raise the head restraint to the full up position. Insert a small diameter tool into the hole on the inboard side of the outboard head restraint guide and pull upward to remove.
3	Rear Seat Head Restraint Guides Tip:  Squeeze the bottom of the head restraint guide together and push up to remove.
4	Rear Seat Shoulder Belt Opening Bezel Refer to Rear Seat Shoulder Belt Opening Bezel Replacement (Tahoe/Yukon/Escalade Rear Seat No. 2)  or Rear Seat Shoulder Belt Opening Bezel Replacement (Avalanche/Escalade EXT) .
5	Rear Seat Back Cushion Cover Use a sharp bladed tool to carefully release the seat back cushion pad from the seat back cushion frame, the pad is glued to the perimeter of the frame. Remove the seat back cushion cover and pad as an assembly then separate as necessary.
6	Rear Seat Back Cushion Pad